We Install, Repair, & Replace any fixture, located in your bathroom, kitchen, garage, or business.
If your current fixture is damaged, or you just looking to upgrade to a newer fixture, 1st Choice Plumbing can help you. May it be in your bathroom or your kitchen faucet, we have a ton of experience in replacing your fixture!
Our labor comes with a Full Year Warranty!
Already have a fixture that you would like installed? Contact 1st Choice Plumbing!
At 1st Choice Plumbing, we can install all types of faucets, whether they are homeowner supplied, or Moen and Delta fixtures that we supply.
We can change out your three handle shower valves and convert it to a single handle without any cosmetic damage to your tile or walls.
We can also Supply kitchen faucets with spraying pull out faucets, High goose neck faucets, two handle, single handle, & faucets in the bathrooms.
We can also supply a 8 inch spread faucet, two handle faucet, & single handle faucets.
At 1st Choice Plumbing, we specialize in installing all sorts of toilets.
We Supply Gerber brand toilets, they start off with a Maxwell, which is a standard basic toilet.
The next stage up is a Viper, a little bit better flushing and the Jet system inside the bowl itself is a little bit better, jets pushing the waist down.
Then they have the Avalanche, which is the next step up, again it is a little better, even with the flush.
The fourth and final is the pressure assisted toilet which is all air compressor, like a commercial toilet but it is a standard looking home toilet.
Installing or replacing a shower or sinks basin, pan, or base is important to have professionally done. If these are not professionally installed, it can often cause water damage to the surrounding floors & walls, and possibly in some cases be unsafe to use. These fixtures are often heavy and not something to take lightly, if not handled with care you can easily damage your shower or sink basin before you even installed in. We can handle all plumbing remodeling needed to install these fixtures, sinks installation will often need a counter top installed with a from to support it. Once installed the drain needs to be connected properly without any leaks, then finally getting the hot water and cold water to run through the faucet properly, once these aspects are taken care of we make sure the work area is cleaned and all extra materials are disposed.
In the case of a shower base installation, it vary’s, depending on the type of fixture you are looking to install. Some or a tub with legs, that bolt to the ground, others want a walk in shower with tile walls and floors, this requires more time and money, and comes with more responsibility when installing.
